Skip to content
LiberoDraft LiberoDraft Help
Deutsch
Start › B How-to › How do I hatch an area?

How do I hatch an area?

  1. Check that the area is completely enclosed by edges — lines, arcs, circles, rectangles, polylines, splines or blocks.
  2. Start Hatch (ribbon Annotate — in a narrow window via the triangle of the collapsed group — or classic toolbar). The Hatch Settings dialog opens next to the drawing.
  3. Choose the pattern in the dialog and set angle and spacing. Changes apply immediately.
  4. Click inside the area. The program searches the boundary and creates the hatch; the status bar reports Hatch created: ANSI31 ….
  5. Click further areas or end the command with Esc.
One click (1) inside the area is enough.
One click (1) inside the area is enough.
Tip

If the area stays empty, the boundary is usually open at a corner. Zoom in on the corners and check the end points with the Endpoint snap mode. Further causes: No closed area found.

Note

With Visible area only (faster) switched on, the whole area must be in view. If it extends beyond, zoom out or switch the option off.

Note

If a hatch would need more than 200,000 lines (very small spacing or very large area), LiberoDraft shows and prints it as a fill in its colour and reports once in red Hatch too dense — shown as a fill, increase the spacing; the set spacing is kept. A boundary without area produces no hatch.

Changing a hatch afterwards

Double-click into the hatch: it is selected, and the panel on the right brings the Properties section into view — with pattern, angle, spacing, colour, opacity, line width, line type, origin, point marks and layer. Changes there apply at once to the selected hatch; an angle of 0° stays 0°.

After the double-click: (1) the hatch is selected, (2) the Properties section shows its values
After the double-click: (1) the hatch is selected, (2) the Properties section shows its values

Related topics