How do I change a block?
Change all instances
- Select an instance and click with the right mouse button → 📐 Edit block. Or the row button 📐 in the panel Blocks.
- The drawing disappears; only the block geometry lies on the canvas, the orange cross is the insertion point.
- Change with all tools — draw, delete, dimension, hatch.
- Click Save in the banner at the top. All instances show the new state. Save is an undo step: Ctrl + Z takes back the whole edit (on a sheet via the Model tab, then Ctrl + Z — the status bar points this out); without a change no step is created. Cancel discards everything that was changed in the editor — also on other blocks, layers, parts list fields and guide lines — without an undo step.
- Dimensions that hang from outside on parts of the block stay on their parts; the dimension of a deleted part is hidden until Ctrl + Z brings the part back (Parts in blocks).

What is locked in the block editor
While the block editor is open, space and sheet stay as they are: tabs, +, Delete layout, Page setup, viewports and Frame + title block are locked. Also locked are saving the drawing (Ctrl + S), deleting and purging block definitions, BOM and the parts list fields of the drawing. A block that is or contains the edited block cannot be inserted — by no route; the status bar reports it in red. Open and New drawing end the editor without writing back (the question about unsaved changes comes first).
An inserted live parts list cannot be edited in the block editor (red message) — you change its cells via Edit parts list… (double-click), and you get a fixed version via Explode. Its right-click menu shows neither Edit block nor BOM data… nor Split off as variant.
Change only some instances
- Select the affected instances — not all of the block.
- Right-click → 🧬 Split off as variant. The program creates Name (2), re-attaches the instances and opens the editor.
- Change and save. The remaining instances stay unchanged; afterwards adjust the BOM data of the variant.
Change one instance freely
Right-click on the instance → Explode: the instance becomes ordinary elements that you edit individually. The definition and the other instances stay untouched. Sub-blocks remain insertions; dimensions on edges become linear dimensions, annotations and groups pass to the pieces, the hatch of the block lies one Z level below its lines, and constraints are removed with a message. Dimensions that hang from outside on a line, circle or arc of the instance become ordinary dimensions on the piece and can drive afterwards. Locked and invisible items are not exploded. Details: Explode.
Change only the name or the BOM data
Right-click → 🧩 BOM data…: block name, designation, article number, material and further fields — without the editor. The form also shows the drawing's own fields (window BOM fields). If an insertion is selected, the Properties panel shows its BOM data with the button BOM data… and the count n× in the drawing · m× in total.