Welding a contour with gaps
Goal
An imported contour consists of lines whose ends do not lie exactly together (gaps below 0.5 mm). The corners should become joints so that the contour can be edited as a whole.
Steps
- Select the lines of the contour — with the rubber band or Ctrl + A if nothing else lies in the drawing.
- Choose Weld (group Constraints; with a narrow window via its triangle or the overflow menu ☰).
- In the dialog enter Tolerance = 0.5 (1) and click Weld (2). If every joint should also count as a constraint, first tick Also add a «coincident» constraint (3) — the box is off by default and is remembered.
- Read the result dialog: it names the number of joints and the elements that had to be shifted — with gaps this is normal. Close with OK.


Result
A green diamond sits at every corner; if you drag a corner point at its grip, both lines follow. If the result is not right, Ctrl + Z takes back the welding completely — including the shifted endpoints and a «coincident» constraint added with it; then try again with a smaller tolerance. Individual joints are released with Unweld (list under Weld). Welds belong to their space (model or sheet); when breaking, splitting, trimming and exploding they pass to the piece that ends at the joint. So that future contours get joints right away, leave auto-weld switched on; rectangles as separate lines, slots and curved slots that you draw in LiberoDraft are welded at their corners anyway (Shapes).