Skip to content
LiberoDraft LiberoDraft Help
Deutsch
Start › E Dialogs › Window Polygon

Window Polygon

What it is for

The polygon tool needs two inputs that do not follow from clicks: the number of corners and the position relative to the circle. Both stand in a small window that opens with the tool and closes with it. It can be moved freely by its title bar.

The window «Polygon»: (1) Corners (N), (2) Position on circle
The window Polygon: (1) Corners (N), (2) Position on circle

The fields

Corners (N) (1) — the number of corners, 3 to 200; a typed value outside is set to the limit, an unreadable one counts as 6. The value can be typed or changed step by step with the buttons − and +. The factory value is 6.

Position on circle (2) — determines how the polygon sits relative to the auxiliary circle you drag while drawing:

EntryEffect
inscribed (corner follows cursor)The corners lie on the circle; the radius is the circumcircle radius. The cursor leads a corner.
circumscribed (side follows cursor)The sides lie tangentially against the circle; the radius is the incircle radius, that is half the width across flats. The cursor leads the middle of an edge.

For hexagon bolts and nuts circumscribed is the right entry: there the width across flats is the dimension given in the standard.

Hint line — below the fields the sequence is repeated in short: click the centre, then drag or enter the radius; Esc cancels.

× (close) — ends the tool (tooltip Finish the tool).

What is remembered

Number of corners and position are kept for the whole session: on the next call of the tool they are still set as you last used them.

The window follows a change of the interface language at once, even while it is open.

Related

Related topics