Skip to content
LiberoDraft LiberoDraft Help
Deutsch
Start › E Dialogs › Window Measure

Window Measure

The window opens with the tool Measure (I) at the top centre above the drawing area. It can be moved by its title and closes with the tool.

The window in mode «Element info» after clicking a circle
The window in mode Element info after clicking a circle

Mode

The list at the top chooses the measuring type: Element info, Distance (2 points), Point (coordinates cart. + polar), Chain measurement (Σ over points), Min. distance (2 elements), Angle (2 lines), Area & perimeter. A change discards the running measurement; the chosen mode stays for the session.

Automatic / Manual

Only in the mode Area & perimeter. Automatic: one click into a closed area finds the contour as when hatching (Hatches). Manual: click the contour elements one by one and finish with Enter; Esc cancels.

Reference, Set reference, ↺

Only in the mode Point. Reference: shows the reference point of the coordinates — Origin or the set coordinates. Set reference expects a click (with object snap) on the new reference point; the status bar reports Point mode: click the reference point. ↺ resets the reference to the origin (Reference point: origin).

Hint

The grey line explains the next step of the chosen mode, for example Click two points (with object snap). ΔX/ΔY are shown in colour..

Result

The table with label and value: in the mode Element info the key values of the element, with Distance distance, angle, ΔX, ΔY and the two points, with the chain measurement Part 1, Part 2 … with running sum Σ, Total and Points, with the area area, perimeter and centroid. All lengths carry the dimension unit of the drawing, areas its square. If the measurement went through a viewport, the line Note: Model values through viewport is shown.

📍 Insert the centroid as a point

Only after an area measurement: puts the calculated centroid as a point element into the drawing (snappable with Point).

Copy

Puts the result lines as text into the clipboard; message Measured values copied, without a result Nothing to copy.

Close

Ends the tool and switches to Select. The coloured auxiliary displays in the drawing disappear; nothing remains.

Related topics