Setting up viewports
Goal
The overview at 1:2 on the left of the sheet, an enlarged detail at 2:1 on the right — the detail without the model’s dimensions.
Steps
- Select the existing viewport (click its frame) and move it to the left half of the sheet using the corner grips.
- Right-click it → “⚙ Viewport settings…”. Enter the scale 1 : 2 (1), then “OK”. If the reference scale prompt appears, choose “Cancel” to keep the current model image.
- Right-click an empty spot → “🗔 Draw new viewport” (1). Click the first and second corner on the right of the sheet.
- Double-click into the new viewport (the frame turns orange), drag the detail into the centre and enlarge it with the wheel; a double-click next to it finishes.
- Right-click the detail viewport → “⚙ Viewport settings…”: enter the scale 2 : 1 and clear the “Dimensions” checkbox under “Show from model” (7), then “OK”.
- “🔒 Lock” both viewports to protect them.



Result
Both viewports show the same model at different scales; the labels at the bottom left read “1:2” and “2:1”, with a padlock on locked viewports.

Tip
“⤢ Fit to contents” always brings the whole model back into the viewport if the view has slipped.
Note
While the block editor is open, viewports, page and sheet cannot be changed.