Filleting and chamfering corners
Goal
A rectangular plate of four lines should get two rounded corners with R 10 and two chamfers 5 × 45°.
Steps
- In the group Modify choose Fillet .
- Click the first line of the corner (1), then the second (2). The field R: appears.
- Type 10 and press Enter — the arc is created in the sector where the pointer is (3); repeat the steps for the second corner.
- Choose Chamfer ; click the first line of the third corner on the side that stays (1), then the second (2).
- In the chamfer field enter D1 = 5 and D2 = 5 — with equal distances the chamfer is 45° — and confirm with Enter; the fourth corner likewise.


Result
Two corners carry a tangent arc, two a bevel; the lines are shortened to the transitions. If a chamfer should have another angle, switch the field to angle and distance with → ∠/D (chamfer field).
Chamfering connected corners
If the corner is bound — by a weld or a «coincident» constraint —, it stays connected when chamfering: the binding passes to the chamfer line (first line ↔ chamfer start, chamfer end ↔ second line). A third line at the same corner is shortened up to the chamfer and bound there if its direction meets the chamfer line. A point dimension at the corner stays at the old position, angular dimensions between the lines keep their value, and the chamfer line joins the common group of both lines. If a line is fixed or a partner at the corner is fixed, Chamfer refuses with a red message (e.g. Element is fixed — chamfer refused); lines on locked layers cannot be picked at all (note with padlock).