Skip to content
LiberoDraft LiberoDraft Help
Deutsch
Start › B How-to › Copying a detail into another drawing

Copying a detail into another drawing

Goal

A connection detail from drawing A should be pasted into drawing B — rotated by 90° and with a hole centre as attachment point.

Steps

  1. In drawing A select the detail and press Ctrl + C — Copied — click the base point (with snap) · ESC = without, paste centered.
  2. Click the hole centre as base point (1); the pointer shows a crosshair, the snap Centre locks in.
  3. Switch to the browser window with drawing B and press Ctrl + V — the detail hangs at the pointer (2).
  4. Press R — the copy rotates by 90°; the placement HUD shows the angle. This also works while the cursor is in the field Angle.
  5. Click the target point — Element(s) pasted (1×) — keep clicking or ESC to finish; end placing with Esc.
(1) base point, (2) the copy at the pointer when pasting
(1) base point, (2) the copy at the pointer when pasting

Result

The detail lies rotated in drawing B, dimensions and hatches have come along. Further clicks before Esc place further copies; H or V mirrors, + / − scales. Within the same drawing with a fixed spacing it is shorter with the tool Copy.

Undo after pasting

One Ctrl + Z undoes the paste completely — including what the copy brought into drawing B: block definitions, new layers and BOM fields, as long as they are not used anywhere else. Ctrl + Y brings everything back. This applies in the model and on the sheets.

If pasting fails

If the clipboard content cannot be inserted (for example a damaged package from another window), drawing B stays exactly as it was; the status bar reports in red “‹name›” not inserted — drawing unchanged (reason). Individual unreadable values are cleaned up while pasting; the message then starts with ⚠ n damaged entries cleaned up · ….

Note

If you copy an inserted live parts list along, it follows the parts of drawing B there; the position balloons follow it. Cells overridden by hand on parts that do not come along only apply if drawing B has exactly one part with the same designation, article number and standard. See Create a parts list.

Related topics