Skip to content
LiberoDraft LiberoDraft Help
Deutsch
Start › B How-to › Cutter path around a contour

Cutter path around a contour

Goal

A closed outer contour should be travelled with a cutter Ø 12 mm; the tool path (centre path, distance 6 mm) should lie in the drawing as geometry.

Steps

  1. Check that the contour is connected at all corners — gaps are closed by Weld with a small tolerance.
  2. In the triangle of the family Offset choose CAM offset ; the window CAM offset opens.
  3. Click an element of the contour (1) — the chain is tracked, the status line reports … elements selected (closed) ….
  4. Enter Distance = 6 in the window; the checkbox Radii at outer corners stays set.
  5. Keep the pointer outside the contour (2) — the preview shows the path outside — and click Create or right-click.
(1) clicked contour element, (2) pointer outside — preview of the path
(1) clicked contour element, (2) pointer outside — preview of the path
Window «CAM offset» with distance, measure, radii, manual selection and «Create»
Window CAM offset with distance, measure, radii, manual selection and Create

Result

The path lies in the drawing (CAM offset: n element(s) created, distance 6.00). For a pocket keep the pointer inside; if the program reports no valid path — the offset is too large for this contour, the cutter is too large for the pocket. For a path with an allowance increase the distance accordingly.

Related topics